PMP-6 - elanportal.com

381kB Size 9 Downloads 23 Views

MANUAL PMP-6 MODULAR PRECISION PANEL ... The frame is designed to slide on the supplied metal straps and can be adjusted to fit in any location between the studs.
PMP-6 MODULAR PRECISION PANEL

APPLICATIONS & INSTALLATION MANUAL

© P/N 40615-144-02

ELAN

HOME

PMP6

SYSTEMS

PRECISION PANEL REFERENCE MANUAL

INTRODUCTION

The PMP6 Modular Precision Panel is the ultimate wire termination solution. Its six rectangular openings accommodate industry standard DecoraTM inserts. These inserts may be custom configured to elegantly and efficiently terminate all of your customer’s connections and provide the finishing touch to any multi-room audio/video or communications system. Whether used in new construction or retrofit applications, the PMP6’s paintable frame mounts easily into the wall, and its removable front panel makes wire termination a breeze. Dimensions: Wall Cutout.................................................. 8.25” W x 10.5” H Exterior Frame Dimensions (installed)..... 9.75” W x 12.0” H

PRECISION PANELS

ELAN PSP12, PHD12, and PZ6 Precision Panels were designed with the custom installer in mind. They are easy to install and virtually eliminate the huge tangle of wires commonly encountered in custom installations. Designed specifically for use in ELAN Z and HD Series multi-zone systems, these Precision Panels are designed to accommodate all of the interconnections between components and facilitate ‘plug-and-play’ hookup of your ELAN system. All Precision Panels feature clearly labeled front and rear connection terminals to accommodate all desired keypad, video, relay, and door station wiring. ELAN Precision Panels will cut hours off every installation and give a clean, professional look to all your trim-outs.

PSP12 Speaker Precision Panel

Page 2

PHD12 HD Series Precision Panel

PZ6 Z-Series Precision Panel

© ELAN Home Systems 2001 • All rights reserved.

ELAN

HOME

PMP6

SYSTEMS

PRECISION PANEL REFERENCE MANUAL

ROUGH -II N CUT-OUT DIMENSIONS: 8.25”W x 10.5”H A new construction bracket (part number PBKT6P) is available for use with the PMP6. The frame is designed to slide on the supplied metal straps and can be adjusted to fit in any location between the studs. See Figure 1. INSTALLATION TIP: The cardboard insert that the PMP6 sits in inside the shipping carton can be used as a Cutout Template.

Figure 1

The frame of the PMP6 is is equipped with four winglets which clamp securely against the PBKT6P Rough-In Bracket when tightened. In retrofit installations, the winglets will clamp against the rear of the drywall. NOTE: The front panel must be removed before the frame can be installed and the winglets can be tightened. See Figure 2.

TRIM -O O UT All wiring is pulled through the PMP6 and connected to the modular DecoraTM insert’s connectors. The inserts are then mounted to the PMP6’s front panel from the rear and screwed in from the front of the PMP6. Dress your wiring neatly, then carefully place the front panel back into the frame and secure with the four supplied screws. See Figure 3.

Figure 2

Figure 3

© ELAN Home Systems 2001 All rights reserved.

Page 3

ELAN

HOME

PMP6

SYSTEMS

PRECISION PANEL REFERENCE MANUAL

STANDARD ELAN RJ-4 45 P INOUT

RJ45 Rear View

Page 4

© ELAN Home Systems 2001 • All rights reserved.

Comments